How to disassemble and replace fluorescent tubes

2022-07-22
  • Detail

This kind of lamp is often seen in our life. It can not only bring us light, but also change the atmosphere of the room. But how to disassemble the fluorescent tube? What should I do if I want to replace it with a new one? Now let me tell you the relevant methods

this kind of lamp is often seen in our life. It can not only bring us light, but also change the atmosphere of the room. But how to disassemble the fluorescent tube? What should I do if I want to replace it with a new one? Now let me tell you the relevant methods

1. How to disassemble the fluorescent tube

first of all, remember to turn off the switching power supply before disassembling it, and do not operate when it is still powered on, otherwise it will endanger people's life safety

secondly, if your lamp is old-fashioned, there will be gaps at both ends of it. Just rotate the internal double needle, pull one end down from the gap, and then pull out the other end

moreover, if your home is an aluminum alloy LED lamp, you need to use a screwdriver to remove it, because there are two cross screws at the two ends of this lamp, but as long as you unscrew it, then the lamp can be easily removed

finally, remove the starter, which is a little the same as removing the lamp tube. Turn it and take it out of the lamp. But you must pay attention to safety when operating. It's best to have family next to you, just in case

2. How to replace a new fluorescent tube

a. if the service life of the fluorescent tube at home really ends, it must be replaced with a new fluorescent tube. The specific operation method is: first disconnect the general power supply, and then insert the purchased lamp tube according to the corresponding position. Generally, the lamp tube can be installed by rotating it. At the same time, it is also to better fix the lamp tube. However, after installing the lamp, if there is flickering, it means that the installation is not in place and needs to be adjusted again. It must be done after the light is no longer flashing

b when replacing a new lamp tube, be sure to remember to install the starter. Because the starter plays a vital role in the lamp, as long as the starter is inserted into its position and screwed tightly to fix it. After installation, you can try to turn on the power switch to ensure that the lamp can be used normally

c. If only one part of the lamp tube is broken, you must find out the reason first, and then deal with it pertinently. But if you are not sure about these operations, it is recommended to find a professional to help you, so that you will be much safer, just spend some money

Xiaobian conclusion: the above is the introduction of how to disassemble the fluorescent tube and how to replace it with a new one. I hope Xiaobian's arrangement will help friends in need in this regard. In addition to mastering the above contents, it is recommended that you should consider well-known brand products when choosing, so as to ensure the service life of fluorescent lamps and avoid the trouble caused by frequent replacement in the future

合肥牛皮癣医院

成都男科医院

潍坊男科医院

Copyright © 2011 JIN SHI